Hi Jared,
This is something I have also been looking at. Is there any particular
brand of XFP you have had success with?
If we take the Cisco "80km" ZR we have TX 0 to 4 dBm and RX -7 to -24
dBm - worst case 24dB budget excluding splices, patches etc. Assuming
0.2dB/km 120km would be right on the limits. I would like to have some
buffer.
Thanks
Ivan
On 5/Sep/2014 1:32 a.m., Jared Mauch wrote:
You should be able to do 120km with a ZR XFP @ 10G without anything.
If you later want to add equipment to the sites, you can look at doubling your
optics and something like this:
http://www.perle.com/products/10-Gigabit-Standalone-Media-Converters.shtml
- Jared
On Sep 4, 2014, at 5:36 AM, Murat Kaipov <[email protected]> wrote:
Hello Guys.
I need connect two PoP's with 10G links. Distance between PoP's nearly
120km. We have fiber optic between PoP's with two regeneration points
located nearly in 40 km between each other. We have not DWDM. Can you advise
some equipment (May be like EDFA) for fiber optic regeneration points
Scheme like this
PoP-1 ---40km---[Regeneration point1]---40km----[Regeneration
point2]-----40km------PoP2
Thank you.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
