I've got an HSRP setup between two 6500's. Today the primary active
router's sup took a dump and failed over to the standby. The blip
caused the standby router to take over the HSRP gateway on each VLAN as
expected. However once the failover was complete on the primary router
it *immediately* took over the GW's again. And of course, before it
had a full routing table so there was several minutes of blackholing.
I thought we'd be protected from this with the following config, but I
guess not:
PRIMARY ROUTER VLAN X:
standby version 2
standby 0 ip x.x.x.x
standby 0 priority 150
standby 0 preempt delay minimum 600
SECONDARY ROUTER VLAN X:
standby version 2
standby 0 ip x.x.x.x
standby 0 preempt delay minimum 600
What am I missing?
Thanks!
~Randy
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
