Hello experts. I'm trying to map multicast traffic to RSVP-TE tunnel, without success. I'm not quite sure what I might be missing (I think it's all there).
Topology is simple: 155.1.1.0/24------Gi0/0/0/0.110----XR1--------MPLS----------XR2-------Gi0/0/0/0.150 Here's the config (the relevant stuff - there's whole RSVP-TE topology already working under it): HEADEND (asr9k) --------------------------- interface tunnel-mte1000 ipv4 unnumbered Loopback0 load-interval 30 destination 2.2.2.2 path-option 10 dynamic ! destination 3.3.3.3 path-option 10 dynamic ! path-selection metric igp affinity ignore ! multicast-routing address-family ipv4 interface tunnel-mte1000 enable router igmp interface tunnel-mte1000 static-group 232.11.11.11 155.1.1.104 ! TAILEND (asr9k) ------------------------- multicast-routing address-family ipv4 core-tree-protocol rsvp-te group-list acl-232 static-rpf 155.1.1.104 32 mpls 1.1.1.1 router igmp interface GigabitEthernet0/0/0/0.150 static-group 232.11.11.11 155.1.1.104 Tunnel is up, I'm trying to ping from 155.1.1.104 which is connected directly to HEADEND router. show mrib route 232.11.11.11 | begin \\( Tue Jul 1 17:29:01.984 UTC *(155.1.1.104,232.11.11.11) RPF nbr: 155.1.1.104 Flags: EID* * Up: 05:35:59* * Incoming Interface List* * GigabitEthernet0/0/0/0.110 Flags: A, Up: 01:19:08* * Outgoing Interface List* * tunnel-mte1000 Flags: F NS LI LVIF, Up: 01:18:30* However, no traffic seems to pass trough tunnel. *show mfib interface tunnel-mte 1000* *Tue Jul 1 17:30:41.257 UTC* *Interface : tunnel-mte1000 (Enabled)* *SW Mcast pkts in : 0, SW Mcast pkts out : 0* *TTL Threshold : 0* *Ref Count : 5* Any chance you could give me a pointer to where I might be wrong? As a side note, I don't see LSP-VIF interface coming up on tailend router. Best Regards! _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
