Hello. This is not specifically tied to one or other device, but I think an interesting question, so I'd appreciate if someone form here could shed some light on this matter.
Basically, we have a situation where our edge switch has a Gb downlink, and should perform shaping with LLQ inside it for proper class traffic and congestion management. Let's say that the shaping needs to be at 100Mbps, because there's downlink on neighboring device with 100Mbps capacity (which can not do any QoS). My question is, if we simply use LLQ on this switch's physical link (with configured bandwidth command at 100Mbps) and not a shaper with it's LLQ, and if the switch and the other device supports flow control which will reduce traffic down to 100Mbps, will this flow control together with LLQ on physical interface be enough to produce same result as if we were to configure shaper at 100Mbps with LLQ? I hope you understand what you mean. Regards _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
