On 6/9/2014 11:37 AM, Pete Lumbis wrote:
If you have a Sup720 pulling a full BGP feed you've probably seen error
messages like this:
*%MLSCEF-SP-4-FIB_EXCEPTION_THRESHOLD: Hardware CEF entry usage is at
95% capacity for IPv4 unicast protocol*
A document was just published on Cisco.com describing the issue and how to
correct it.
http://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-series-switches/117712-problemsolution-cat6500-00.html
Do 'remote command switch show bootvar' and ensure that the SP config
register is what you expect. If not, reset the config register and copy
run start, then recheck. Otherwise, you'll set yourself up for
auto-reboots every five minutes of uptime.
pt
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
