Hello, In XR you should be using the following to configure a static route meant for RPF checking.
multicast-routing address-family ipv4 static-rpf "prefix" "mask" "NH-int" "NH-ip" adam > -----Original Message----- > From: cisco-nsp [mailto:[email protected]] On Behalf Of > redscorpion69 > Sent: Tuesday, May 27, 2014 5:36 PM > To: [email protected] > Subject: [c-nsp] static mroute asr9k > > Hello. > > How do I make IOSXR use configuration in "router static address-family ipv4 > multicast" for rpf check instead of default unicast table? I couldn't really > find > documentation on this. I don't want to create additional topologies. > > Regards > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
