Hi gents, I am facing issues in xconnect, encapsulation is l2tp and xconnect is showing up, but the traffic is not passing, any suggestions? configuration is below:
interface GigabitEthernet9/8.2521 encapsulation dot1Q 2521 xconnect 10.11.52.6 200 encapsulation l2tpv3 pw-class 200 end pseudowire-class 2521 encapsulation l2tpv3 ip local interface Loopback0 ! #sh xconnect all Legend: XC ST=Xconnect State S1=Segment1 State S2=Segment2 State UP=Up DN=Down AD=Admin Down IA=Inactive SB=Standby HS=Hot Standby RV=Recovering NH=No Hardware XC ST Segment 1 S1 Segment 2 S2 ------+---------------------------------+--+---------------------------------+-- UP ac PO1/2/0(PPP) UP mpls 10.11.52.1:400 UP UP ac Gi9/8.2521:200(Eth VLAN) UP l2tp 10.11.52.6:2521 UP PE-II interface GigabitEthernet3/0/2.2521 encapsulation dot1Q 2521 xconnect 213.132.242.208 200 encapsulation l2tpv3 pw-class 200 end #sh xconnect all Legend: XC ST=Xconnect State S1=Segment1 State S2=Segment2 State UP=Up DN=Down AD=Admin Down IA=Inactive SB=Standby HS=Hot Standby RV=Recovering NH=No Hardware XC ST Segment 1 S1 Segment 2 S2 ------+---------------------------------+--+---------------------------------+-- UP pri ac Gi3/0/2.2521:200(Eth VLAN) UP l2tp 213.132.242.208:200 UP pseudowire-class 200 encapsulation l2tpv3 ip local interface Loopback0 THanks Raheel _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
