Hi, I need to configure a Cisco 3750 with route maps and so I upgraded from an old LAN base image to IP Services (c3750-ipservicesk9-mz.122-55.SE8.bin) and changed the SDM profile to 'access'
sh sdm prefer The current template is "aggregator access IPv4" template. The selected template optimizes the resources in the switch to support this level of features for 8 routed interfaces and 1024 VLANs. number of unicast mac addresses: 6K number of IPv4 IGMP groups + multicast routes: 1K number of IPv4 unicast routes: 12K number of directly-connected IPv4 hosts: 6K number of indirect IPv4 routes: 6K number of IPv4 policy based routing aces: 0.5K number of IPv4/MAC qos aces: 0.875k number of IPv4/MAC security aces: 4K However, now when I apply a created route-map to an interface, it take the 'ip policy route-map' command but nothing appears on configuration for the SVI. If I apply a non-existent policy map to the same interface, the configuration shows up on the SVI. Anyone know what's going on here? Thanks, -- Michael _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
