The goal is using the device for Internet Traffic with QoS enable. What's the difference between sub-rate and line-rate device ?
2013/12/26 Bill Blackford <[email protected]> > A few years back, I went with a pair of ASR1002's.s 1. My traffic was > 400Mbps and with that particular mix, had lots and lots of small packets. > Hence, microbursts were enough to make the single 7301 fall over on > occasion. 2. My traffic was trending on a 150% increase every two years. I > found it necessary to design for what I need in 3 - 4 years vs. "what I > need now". In my opinion, if you have that much traffic, don't invest in > sub-rate devices, go with line-rate. You might discover down the road that > your traffic may change, as mine did, or you may be compelled to enable > features you hadn't thought of at purchase time that yield performance > penalties. > > > On Thu, Dec 26, 2013 at 6:48 AM, Darwin Santana < > [email protected]> wrote: > >> Hi All, >> >> Can I handle a 400 Mbps or up the bandwidth on the Router 3925E? >> >> Best Regards, >> >> Darwin >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ >> > > > > -- > Bill Blackford > > Logged into reality and abusing my sudo privileges..... > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
