Looks very similar to this RFP - http://www.gju.edu.jo/admin/u1files/GJU%20RFP.pdf
> Date: Sat, 30 Nov 2013 19:45:57 +0300 > From: [email protected] > To: [email protected] > Subject: [c-nsp] Data Center Core Switches > > Dear Experts, > > I am in the process to acquire and implement network infrastructure > solution by upgrading the Data Center Core Switches with a very high > forwarding rate at least 500 Mpps and above, by using the following > (TECHNICAL SPECIFICATION) > > > 1. Modular Switch with Minimum 8 slots > > 2. Minimum switching capacity per slot 200Gbps > > 3. Switching capacity for chassis minimum 5Tbps > > 4. All major components including but not limited to control plane and > power supply should be redundant where failure in one component will not > cause any > failure. > > 5. The switch must support virtualization where 2 switches can act as one > switch eliminating need for spanning tree. > > 6. Energy saving (power consumption to be provided) > > 7. Supports for the following: > a. VRRP > b. NSR: Non-Stop Routing and Non-Stop Forwarding. > c. Stateful or Graceful Switchover. Or equivalent. > d. BFD bidirectional Forwarding Detection > e. Hot Swappable modules. > > 8. The vendor should provide all licenses to support IPv4 and IPv6 full > features. > > 9. Non-blocking, 1 and 10GE design > > 10. Support at least 500 Mpps > > 11. 10GE wire speed to provide adequate support for future collaboration > applications (video, voice and high bandwidth apps) > > 12. Future support of 40 and 100 GE > > 13. The Switch should support, but not be limited to the following Layer3 > Protocols: > a. Static IP routing > b. Routing Information Protocol (RIP) and RIP2 > c. Open Shortest Path First (OSPF) > d. BGP > > 14. The switch must support IP multicast protocols > a. IGMP v1, v2, and v3 > b. IGMP Snooping > c. PIM-SM, PIM DM, PIM-SSM > > 15. The switch should support the following features at a minimum: > a. Spanning Tree 802.1D, 802.1s, 802.1w > b. 802.1X single and multi-supplicant: VLAN and ACL assignment > c. DHCP Snooping, IP source guard > d. LLDP, LLDP-MED > e. 802.3ad > f. Must support Multiprotocol Label Switching (MPLS) in hardware to enable > VPN services within the campus. > g. SNMP Support v1,2,3 > > The above spec could apply to juniper, cisco, hp, xtreme ...etc, any > recommendation should I add/adjust to my TECHNICAL SPECIFICATION > > -mad > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
