What "normally" happens is you put a helper image on bootflash: and install a CF/PCMCIA flash card in disk0: or disk1: to hold the main boot image
On 19 Nov 2013, at 2:56 pm, Adam Fitzgerald <[email protected]> wrote: > Thanks for the link and the replies guys! > > I see that to upgrade the internal module you need to CF adapter, I think > this is where my reseller was confusing me as they didn't mention this. > > I guess then I can just use the disk0 slot in the front of the sup720 and > boot the image from this instead? As there are separate SP and RP boot > flash internally, would I be right in assuming that I can use 2 CF cards > and set the boot variable for the SP and RP to point to disk0 and disk1 > external CF cards respectively? > > Alternatively would it be best to get the internal CF adapter and card long > term? > > > > On Tue, Nov 19, 2013 at 2:43 PM, Sidney Boumendil < > [email protected]> wrote: > >> >> >> >> 2013/11/19 Adam Fitzgerald <[email protected]> >> >>> Hey guys, >>> >>> I am struggling to understand if I can upgrade the internal bootflash >>> module on a WS-SUP720-3B, to 512mb (from 64mb). >>> >> >> If I understand correctly what you are tryin to achieve, yes it possible >> to: >> http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_17277.html >> Keep in mind the ROMMON version requirements. >> >> HTH >> > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
