Thanks for the kind reply When I configure ip route 0.0.0.0 0.0.0.0 using the exit interface and configure network 0.0.0.0 under the router eigrp configuration mode , the dafualt route reaches the routers in the eigrp domain , while when using the next-hop IP address I have to use the redistribute static command? Thanks
> Date: Mon, 2 Sep 2013 12:51:09 +0400 > From: [email protected] > To: [email protected] > CC: [email protected] > Subject: Re: [c-nsp] EIGRP Metric > > Because router calculates metrics from himself to destination , not from > neighbor to destination. > this is Advertised distance , when R5 recieves routes from R1 with AD , > R5 will add its metrics to R1 which will be FD > > On 09/02/2013 12:45 PM, M K wrote: > > Hi allI have the below topology > > R1 E1/0 - R5 F1/0 > > Its connected via a layer 2 switch , I have advertised Loopback interface > > on R1 (1.1.1.1)now , the route is installed in R5 routing tableMy concern > > is that E1/0 has a BW value of 10000 and delay of 1000 , F1/0 of R5 has BW > > value of 100000 and delay of 100When I checked the Metric of the route (FD) > > on R5 , all calculations were based on F1/0 values and the values of E1/0 > > were ignored , why? > > Thanks > > _______________________________________________ > > cisco-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
