Hi, It depends on the mode your telnet is working:
If it's sending LINE-by-LINE, then you will see fewer pakets and bytes, and longer contents (for example, your password sent in clear thru telnet protocol) will cause bigger packets, or even more of them if contents does not fit into one. But Normally, a line of say 80 characters will fit into one paket. If it's sending letter-by-letter, you will see more pakets and bytes because of the overhead. I don't think that this answers your RealQuestion(TM) , but i Hope this help's, Juergen. > -----Ursprüngliche Nachricht----- > Von: cisco-nsp [mailto:[email protected]] Im Auftrag > von M K > Gesendet: mardi 30 juillet 2013 02:26 > An: Tony; [email protected] > Betreff: Re: [c-nsp] QoS > > Hi and sorry for the late replyNo , it's not a tricky question I want > to understand how the counts are calculated , if I entered a larger > password will it really matters? > > Date: Thu, 25 Jul 2013 03:09:26 -0700 > From: [email protected] > Subject: Re: [c-nsp] QoS > To: [email protected]; [email protected] > > Is this a trick question ? > > Every time it sees a packet that matches the criteria you have > specified and is put into your class it increments the "packets" > counter by 1 and adds the size of the packet to the "bytes" counter. > > What is or isn't happening that you're concerned about ? > > regards, > Tony. > > From: M K <[email protected]> > To: "[email protected]" <[email protected]> > Sent: Tuesday, 23 July 2013 8:10 PM > Subject: [c-nsp] QoS > > Hi allI have configured QoS between two sites across my backbone , the > classification was done based on telnet traffic and the marking was > done based on the precedence valueI have configured to mark all telnet > traffic with precedence value of 3 and I received it fine without any > issues > Now my question is as belowWhen I first wrote telnet 7.7.7.7 and > checked the output of show policy-map interface fastEthernet 1/0 | inc > Class|packet > telnet 7.7.7.7 Class-map: PRECEDENCE_3 (match-all) 9 packets, > 520 bytesUsername : cisco Class-map: PRECEDENCE_3 (match-all) > 16 packets, 905 > bytesPassword : cisco Class-map: PRECEDENCE_3 (match-all) 23 > packets, 1290 bytesR7>exit Class-map: PRECEDENCE_3 (match-all) > 30 packets, 1674 bytes > I want to know what is the methodology used to count these numbers ? > Thanks > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
