Hello. Do you have a corresponding entry in the mpls forwarding database for the next hop address?
Bästa hälsningar / Best regards, Gustav Uhlander Communication & Infrastructure Engineer Steria AB Kungsbron 13 Box 169 SE-101 23 Stockholm Sweden Tel: +46 8 622 42 15 Fax: +46 8 622 42 23 Mobile: +46 70 962 71 03 [email protected] www.steria.se From: Nick Ryce <[email protected]> To: "[email protected]" <[email protected]> Date: 2013-06-06 20:11 Subject: [c-nsp] Fwd: BGP Signalled VPLS on ME3600 Sent by: "cisco-nsp" <[email protected]> Hi, Im having a strange issue with a BGP signalled VPLS on my ME3600. I'm running 15.3.2(s). The VFI comes up but the virtual circuit stays down with the following error:- SW1.THN-LON#show mpls L2transport vc 501 detail Local interface: VFI FLVPLS001 vfi up Interworking type is Ethernet Destination address: 46.226.0.10, VC ID: 501, VC status: down Last error: MPLS dataplane reported a fault to the nexthop Output interface: none, imposed label stack {} Preferred path: not configured Default path: no route No adjacency Create time: 00:19:42, last status change time: 00:19:42 Last label FSM state change time: 00:19:42 Signaling protocol: BGP Status TLV support (local/remote) : Not Applicable LDP route watch : Not Applicable Label/status state machine : activating, LruRruD Last local dataplane status rcvd: DOWN(pw-tx-fault) Last BFD dataplane status rcvd: Not Applicable Last BFD peer monitor status rcvd: Not Applicable Last local AC circuit status rcvd: No fault Last local AC circuit status sent: DOWN(pw-rx-fault) Last local PW i/f circ status rcvd: No fault Last local LDP TLV status sent: Not Applicable Last remote LDP TLV status rcvd: Not Applicable Last remote LDP ADJ status rcvd: Not Applicable MPLS VC labels: local 27, remote 16 Group ID: local 0, remote 0 MTU: local 1500, remote 1500 Control Word: Off Dataplane: SSM segment/switch IDs: 0/10075 (used), PWID: 12 VC statistics: transit packet totals: receive 0, send 0 transit byte totals: receive 0, send 0 transit packet drops: receive 0, seq error 0, send 0 The next hop is available and routable so not quite sure what the issue is. Any help greatly appreciated. Nick _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
