Given that this is a 1G in a 10G port, you might need to add "speed 1000" to the interface config?
Best regards, Andras On Mon, Dec 10, 2012 at 8:12 PM, Lobo <[email protected]> wrote: > Hi everyone. Been having a hard time trying to get a copper SFP to work > on our ME-3600X-24TS-Ms. According to Cisco documentation, the GLC-T SFP > is supposed to be supported on one of the fiber ports. However every Cisco > SFP we've tried always spits back an error message: > > Switch# > > *Dec 6 19:48:30.448: %PHY-4-SFP_NOT_SUPPORTED: The SFP in Te0/1 is not > supported > > *Dec 6 19:48:30.448: %PM-4-ERR_DISABLE: gbic-invalid error detected on > Te0/1, putting Te0/1 in err-disable state > > Switch# > > > Has anyone had any success with trying to use these on this platform? > Fiber based SFPs are fine so long as they're Cisco branded. Are there > different versions of GLC-T that we may have the wrong type? > > Thanks. > > Jose > ______________________________**_________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/**mailman/listinfo/cisco-nsp<https://puck.nether.net/mailman/listinfo/cisco-nsp> > archive at > http://puck.nether.net/**pipermail/cisco-nsp/<http://puck.nether.net/pipermail/cisco-nsp/> > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
