Hi,
May be you could use something like this:
ip route 192.168.0.1 255.255.255.255 Null0
route-map DROP permit 10
set ip next-hop 192.168.0.1
HTH
Mohammad Khalil wrote:
Hi all
i am trying to simulate ICMP drops via PBR
route-map DROP permit 10
match ip address ICMP
match interface FastEthernet0/0.67
match length 100 100
set default interface Null0
Rack1R6(config)#route-map DROP
Rack1R6(config-route-map)#set interface null 0
% route-map:can not set interface.
% Use P2P interfaces for set interface clause
any ideas to work around this ?
i have tried the set default interface null 0 , the router takes the command ,
but after applying the set interface null 0 command it show the same message
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
