Daniel- Depending on IOS, start by issuing the command "show diagnostic results mod 3" and look for any tests that have failed. If you do see any failed tests (F's), try re-seating the module. Software's most likely not the issue since you've got the same blade, online and fine. If the test fails again, you're most likely looking at bad hardware, depending on what test(s) failed. Definitely don't let this slide if you can avoid it...some failed tests won't affect your network and some will, depending on flows and what physical interfaces you're actually using.
-- Stephen F. Cobb • Senior Sales Engineer, CCNA/CCDA/DCNID/CSE Telecoast Communications, LLC • Santa Barbara, CA o 877.677.1182 x272 • c 760.807.0570 • f 805.618.1610 aim/yahoo telecoaststephen On Mon, Mar 8, 2010 at 10:16 AM, Daniel Baumann <[email protected] > wrote: > Hello, > I'm using a 4506 as my core switch. This morning I noticed an issue with my > line card 3: > > Switch#sh module > Chassis Type : WS-C4506 > > Power consumed by backplane : 0 Watts > > Mod Ports Card Type Model Serial > No. > > ---+-----+--------------------------------------+------------------+----------- > 1 2 Supervisor IV 1000BaseX (GBIC) WS-X4515 > JAE0806XXXX > 2 48 100BaseFX (FX-MT) WS-X4148-FX-MT > JAB0808XXXX > 3 48 1000BaseX (SFP) WS-X4448-GB-LX > JAB0701XXXX > 4 48 1000BaseX (SFP) WS-X4448-GB-LX > JAB0734XXXX > 5 24 10/100/1000BaseT (RJ45) WS-X4424-GB-RJ45 > JAB0804XXXX > 6 48 10/100/1000BaseT (RJ45) WS-X4448-GB-RJ45 > JAB0803XXXX > > M MAC addresses Hw Fw Sw > Status > > --+--------------------------------+---+------------+----------------+--------- > 1 000f.34d3.9480 to 000f.34d3.9481 3.1 12.1(20r)EW1 12.2(25)EWA10 Ok > 2 000f.34a5.dde0 to 000f.34a5.de0f 1.0 Ok > 3 000b.be7d.5990 to 000b.be7d.59bf 2.0 > Faulty > 4 000d.bd8a.a130 to 000d.bd8a.a15f 2.1 Ok > 5 000d.657c.fc60 to 000d.657c.fc77 1.5 Ok > 6 000f.2319.7490 to 000f.2319.74bf 1.1 Ok > > > None of the network devices attached to this line card seem to be affected > in any way (yet?). > How would I go about finding out what's wrong with it? Should I start > looking for a replacement? > > Thanks, > -Dan > > > > > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
