Hi All, I have some problem which i need to solve I have two Cisco 1841 routers For one of them CE i have Wan interface and ethernet interface (customer side) For second of them PE i have Wan interface andvlan sub-interface (customer side)
I try to build xconnect over L2TPv3 tunnel between them But i observed that session was established only on CE side, and not connected on PE side What can i do that tunnels was working? Can i build L2TPv3 Session Xconnect between an Ethernet Interface and VLAN Subinterface? --------------------------------------- configuration on CE l2tp-class interworking-class ! pseudowire-class inter-L2TP-TUNNEL encapsulation l2tpv3 protocol none ip local interface FastEthernet0/0 ! # Wan interface interface FastEthernet0/0 ip address 193.xxx.xxx.1 255.255.255.192 duplex auto speed auto ! # customer side interface interface FastEthernet0/1 no ip address duplex auto speed auto no cdp enable xconnect 195.xxx.xxx.2 60 encapsulation l2tpv3 manual pw-class inter-L2TP-TUNNEL l2tp id 17437 31507 -------------------------------------- configuration on PE l2tp-class interworking-class ! pseudowire-class inter-L2TP-TUNNEL encapsulation l2tpv3 protocol l2tpv3 interworking-class ip local interface FastEthernet0/1.264 ! # Wan interface interface FastEthernet0/1.264 encapsulation dot1Q 264 ip address 195.xxx.xxx.2 255.255.255.252 ! # customer side interface interface FastEthernet0/1.602 encapsulation dot1Q 602 no cdp enable xconnect 193.xxx.xxx.1 60 pw-class inter-L2TP-TUNNEL _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
