Any ideas how to troubleshoot this ? Thanks.
Regards, Antonio Soares, CCIE #18473 (R&S) [email protected] -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Antonio Soares Sent: terça-feira, 24 de Novembro de 2009 11:46 To: [email protected] Subject: [c-nsp] Runts in the network Hello Group, I have 7200's acting as PE's and running 12.4.23 that show an abnormal numbers of runts. The interfaces where this can be seen are E1 channel-groups configured for frame-relay. This is the typical configuration: ! frame-relay switching ! controller E1 x/y channel-group 0 timeslots 1-31 ! interface Serialx/y:0 encapsulation frame-relay frame-relay traffic-shaping frame-relay lmi-type ansi frame-relay ip rtp header-compression frame-relay intf-type dce ! interface Serialx/y:0.100 point-to-point ip vrf forwarding MY-VRF ip address x.x.x.x x.x.x.x ip rip advertise 10 frame-relay interface-dlci 100 class MY-CLASS frame-relay ip rtp header-compression ! The E1 is completely clean but the serial interface shows runts: ROUTER#sh int sx/y:0 Serialx/y:0 is up, line protocol is up (...) Received 0 broadcasts, 12 runts, 0 giants, 0 throttles 12 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort (...) ROUTER# This happens everywhere in the network and there are many 7200's. The PA is the PA-MC-8TE1+. What could be the source of the problem ? I know what a runt is but i would like to understand why i have it all over the network. Thanks. Regards, Antonio Soares, CCIE #18473 (R&S) [email protected] _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
