Hey all,
Just for the record, it seems my issue was tied into using an xconnect
statement on a port on a 16 port ESW module, even though there was a 'no
switchport' on there. Upgrading to 12.4(25b) didn't fix it, in fact, it made
it worse, no traffic in either direction. But when I moved the xconnect to the
built-in ethernet port, and used subints for VLANs, no issue, worked like it
should.
P.S. Throughput seems pretty good. Random frame sizes (even dist) from 600
bytes to 1400 bytes (avoiding any fragmentation) had 95 mbit bi-directionally
at 90% CPU on the 3660. All interrupt traffic.
Chuck
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Church, Charles
Sent: Wednesday, November 18, 2009 5:05 PM
To: nsp-cisco
Subject: [c-nsp] One-way traffic using L2TPv3
Anyone,
Labbing up L2TPv3 on a couple routers back to back, having some
issues with just one way traffic. Topology looks like this:
Ixia(port3)----Fa1/8(3660)Fa0/0----Fa0/0(3660)Fa1/8----(port4)Ixia
Both Ixia ports are sending traffic, but only port4 is receiving any traffic.
Port Fa1/8 on the right 3660 shows packets coming in, but 'sh l2tun sess pack'
on the right 3660 doesn't show any packets in, which the fa0/0 interface
counters confirm. Any idea what would cause this one-way behavior? When I put
the 4 ports in a bridge groups (Ieee), traffic flowed as expected, so I know
the Ixia isn't to blame. Relevant config:
R3 (left)
l2tp-class testclass
authentication
password 7 05080F1C2243
!
pseudowire-class test-pclass
encapsulation l2tpv3
protocol l2tpv3 testclass
ip local interface FastEthernet0/0
ip pmtu
!
!
interface FastEthernet0/0
ip address 10.0.0.1 255.255.255.252
ip flow ingress
duplex auto
speed auto
!
!
interface FastEthernet1/8
no switchport
no ip address
no cdp enable
xconnect 10.0.0.2 400 encapsulation l2tpv3 pw-class test-pclass
!
R4(right)
l2tp-class testclass
authentication
password 7 05080F1C2243
!
pseudowire-class test-pclass
encapsulation l2tpv3
protocol l2tpv3 testclass
ip local interface FastEthernet0/0
ip pmtu
!
!
interface FastEthernet0/0
ip address 10.0.0.2 255.255.255.252
ip flow ingress
duplex auto
speed auto
hold-queue 150 out
!
!
interface FastEthernet1/8
no switchport
no ip address
no cdp enable
xconnect 10.0.0.1 400 encapsulation l2tpv3 pw-class test-pclass
!
Any ideas? IOS is 12.4(10) IK9S , platform is 3660.
Thanks,
Chuck
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
