Antonio Soares wrote:
Thank you for this feedback. So it must be something related with the ES card.
You have an ES+ and i have an ES. I need to check the
ES+ documents to see if there is a reference to this.
Regards,
Antonio Soares, CCIE #18473 (R&S)
[email protected]
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Tassos Chatzithomaoglou
Sent: quarta-feira, 23 de Setembro de 2009 8:51
To: [email protected]
Subject: Re: [c-nsp] 7600-ES20 L2 and L3 Multiplexing
I'm using SRD2 and ES+ cards, but i haven't met your issue.
IPv6 is working fine under subinterfaces, together with other service instances
on the same physical interface.
Hello !!
I think something is being altered on the way from SRB do SRD release
I also have ES20 card , and with SRB it was possible to config ip main
interface ( ip , mpls ..)
and below it , service instances for l2 vlans
Like this
int ten2/0/0
ip address 192.168.100.1 255.255.255.0
mpls ip
ip router isis
service-policy output 10G
!
service instance 2000 ethernet
encapsulation dot1q 2000
bridge-domain 2
With SRD you can't have such config , such error is displayed :
(config-if)#service instance 2000 ethernet
L2 service instance can not be configured on this interface because IP
address is already configured
also cyt
Scalable EoMPLS on Cisco 7600 Series ES+ Line Cards :
Because HWEoMPLS is not supported on the ES+ line card, the xconnect
command will be rejected on the main Layer 3 interface and Layer 3
subinterface.
But we talk about ES cards .. , and I confirm - your config was possible
with SRB6 , and it's not with SRD3 ( exactly ipv6 addr on subinterf is
rejected :) )
//regards Piotr Sawicki
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
