Group,
I'm trying to figure out why i have this output:
++++++++++++++++++++++++++++++++++++++++++++++
12k2>sh env power_supply
Failsafe power system
Slot # 48V AMP_48
(Volt) (Amp)
27 PEM1 53 10 Failsafe-PEM= Failsafe PS
PEM2 No module detected
PEM3 No module detected
PEM4 No module detected
12k2>
++++++++++++++++++++++++++++++++++++++++++++++
When i have a similar 12k showing this:
++++++++++++++++++++++++++++++++++++++++++++++
12k1>sh env power_supply
DC Power Supplies
Slot # 48V AMP_48
(Volt) (Amp)
27 PEM1 52 4 PWR-GSR16-DC= Standard DC PS
PEM2 52 7 PWR-GSR16-DC= Standard DC PS
PEM3 54 16 PWR-GSR16-DC= Standard DC PS
PEM4 55 20 PWR-GSR16-DC= Standard DC PS
12k1>
++++++++++++++++++++++++++++++++++++++++++++++
Both 12k's have 4 2000W DC Power Supplies.
The only thing i was able to verify is that in 12k2, Zone 2 Power Consumption
is above 2000W. Could this lead to the apparently
abnormal situation above ?
Thanks.
Regards,
Antonio Soares, CCIE #18473 (R&S)
[email protected]
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
