On Wed, Mar 16, 2022 at 7:05 AM Andreas Führmann via chirp_users <chirp_users@intrepid.danplanet.com> wrote: > > Hi there, > > just aquired an RA 685 and programmed it with Chirp. For emergency reasons I > have also added frequencies outside of the ham band. Now the mistery begins. > The radio came open with transmit from 136 to 178 MHz and from 400 to 480 > MHz, which is working without any problem but only in VFO mode. When I go to > channel mode f.I. on 446 MHz (European PMR), it will not transmit. Maybe I‘ve > overseen a check box or is there any trick to overcome this issue? Thanks in > advance. > > 73 de DC3AFA, Andy
Hi Andy, It is not a mystery. CHIRP has been programmed to behave the same way the factory programming software works (TX/RX 144-148 MHz and 430-440 MHz). Unlike the factory software, CHIRP allows you to also add RX only frequencies in the 136-174 MHz and 400-480 MHz range. Jim KC9HI _______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to arch...@mail-archive.com at arch...@mail-archive.com To unsubscribe, send an email to chirp_users-unsubscr...@intrepid.danplanet.com To report this email as off-topic, please email chirp_users-ow...@intrepid.danplanet.com
