Hi Folks,
I finally got an antenna outside for my Kenwood that I have in the shack.
There are so many buttons on this radio, and I am a Blind Ham, but even with
the speech chip on the Kenwood, it is daunting to learn all of its functions.
I've have already messed it up so bad that I had to do a full reset.
So I thought I'd set it up with Chirp, so I can recover if I mess it up again.
I've used Chirp for my HT radios, so I'm a bit familiar with using Chirp.
I'm working on trying to get an old computer with serial ports working for the
shack, but until then I will need to connect to the Kenwood with a laptop that
has no serial ports.
I have a USB to serial cable somewhere, but I cannot find it.
I did find a serial to Ethernet cable, and I am wondering if the Chirp software
will be able to connect to the Kenwood via the laptop's Ethernet port with this
cable.
Seems like all of the Chirp connection options are all serial and one USB.
Thanks for any knowledge.
Glenn
_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to arch...@mail-archive.com at arch...@mail-archive.com
To unsubscribe, send an email to chirp_users-unsubscr...@intrepid.danplanet.com
