Hi DR,
This looks like a cable / driver / connector issue. Please refer to
these Wiki articles:
CableGuide
CableGuide FTDI OEM Cables
*Linux notes:* Linux generally is quite good with USB to Serial
converter drivers. The most likely cause for grief is a connector which
doesn't provide good electrical contact. In your case, it looks like
serial TX is not making contact. Check your cable and connector.
73 es GL
Bernhard AE6YN
On 01-Jan-21 13:17, D.J.J. Ring, Jr. wrote:
I can download from my Yaesu FT-897D successfully using CHIRP
daily-20201221 on Linux - Debian GNU/Linux 10 (Python 2.7.16) but I
cannot upload.
I get the following error message.
raise errors.RadioError("Failed to communicate with radio: %s" % e)
RadioError: Failed to communicate with radio: Radio did not ack block 0
ERROR: ----------------
ERROR: Clone failed: Failed to communicate with radio: Radio did not
ack block 0
ERROR: --- Exception Dialog: Failed to communicate with radio: Radio
did not ack block 0 ---
ERROR: None
Full errors in attachment.
Any suggestions?
73
DR
N1EA
_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to Bernhard Hailer at ae...@arrl.net
To unsubscribe, send an email to chirp_users-unsubscr...@intrepid.danplanet.com
_______________________________________________
chirp_users mailing list
chirp_users@intrepid.danplanet.com
http://intrepid.danplanet.com/mailman/listinfo/chirp_users
This message was sent to arch...@mail-archive.com at arch...@mail-archive.com
To unsubscribe, send an email to chirp_users-unsubscr...@intrepid.danplanet.com
