If you bring it here, I'll take a look.
> On 25 November 2019 at 19:43 Eckart Jansen <eckart.jan...@gmail.com> wrote: > > > Hello, I’m a new user trying to do a memory dump to CHIRP using CLONE on a > Yaesu VX5. > > Using a standard serial port to 4-pole plug cable into the VX5 MIC jack. > > WinXP SP3 and CHIRP daily-20191119. > > Serial port COM1 seems to be working properly. > > “CLONE TX” is initiated on the VX5. > > Progress bar appears and moves from start to completion. > > Then a window appears “An error has occurred”, “Checksum Failed > [0000-1FB9(@1FBA)]" > > The VX4 display hangs at “CLONE TX” > > Note that I also tried with a properly installed USB-Serial cable connecting > to COM5 (different serial port) with exactly the same behavior as above. > > Any suggestions on how to get this working? > > _______________________________________________ > chirp_users mailing list > chirp_users@intrepid.danplanet.com > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to Nigel Gunn, W8IFF at ni...@ngunn.net > To unsubscribe, send an email to > chirp_users-unsubscr...@intrepid.danplanet.com Nigel A. Gunn, ///shoulders.outwards.resolutions tel +1 937 825 5032 Amateur Radio G8IFF W8IFF and GMRS WRBV701, e-mail ni...@ngunn.net www http://www.ngunn.net _______________________________________________ chirp_users mailing list chirp_users@intrepid.danplanet.com http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to arch...@mail-archive.com at arch...@mail-archive.com To unsubscribe, send an email to chirp_users-unsubscr...@intrepid.danplanet.com
