> -----Original Message----- > From: ceph-users [mailto:ceph-users-boun...@lists.ceph.com] On Behalf Of > Matyas Koszik > Sent: 07 July 2016 11:26 > To: ceph-users@lists.ceph.com > Subject: [ceph-users] layer3 network > > > > Hi, > > My setup uses a layer3 network, where each node has two connections (/31s), > equipped with a loopback address and redundancy is > provided via OSPF. In this setup it is important to use the loopback address > as source for outgoing connections, since the interface > addresses are not protected from failure, but the loopback address is. > > So I set the public addr and the cluster addr to the desired ip, but it seems > that the outgoing connections do not use this as the source > address. > I'm using jewel; is this the expected behavior?
Do your public/cluster networks overlap the physical connection IP's? From what I understand Ceph binds to the interface whose IP lies within the range specified in the conf file. So for example if public addr = 192.168.1.0/24 Then your loopback should be in that range, but you must make sure the physical nics lie outside this range. I'm following this with interest as I am about to deploy something very similar. > > Matyas > > > _______________________________________________ > ceph-users mailing list > ceph-users@lists.ceph.com > http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com _______________________________________________ ceph-users mailing list ceph-users@lists.ceph.com http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
