I use RGW with the .rgw.bucktes as EC pool and works fine as well, I’m able to reach ~300MB/s using a physical RGW server with 4 OSD nodes with SAS 10K drives w/out SSD journal.
Also, I’ve tested create all other pools as EC pool too but RGW daemon doesn’t start, so I realised that the only pool should be EC was the data pool (.rgw.buckets) Regards. Italo Santos http://italosantos.com.br/ On Tuesday, May 5, 2015 at 22:35, Somnath Roy wrote: > Hi, > I am planning to setup RGW on top of Erasure coded pool. RGW stores all of > its data in the .rgw.buckets pool and I am planning to configure this pool as > erasure-coded. I think configuring all other rgw pools as replicated should > be fine as they don't store lot of data. > Please let me know if I am missing anything, any > comments/suggestion/performance tuning insight on this will be very helpful. > > Thanks & Regards > Somnath > > ________________________________ > > PLEASE NOTE: The information contained in this electronic mail message is > intended only for the use of the designated recipient(s) named above. If the > reader of this message is not the intended recipient, you are hereby notified > that you have received this message in error and that any review, > dissemination, distribution, or copying of this message is strictly > prohibited. If you have received this communication in error, please notify > the sender by telephone or e-mail (as shown above) immediately and destroy > any and all copies of this message in your possession (whether hard copies or > electronically stored copies). > > _______________________________________________ > ceph-users mailing list > ceph-users@lists.ceph.com (mailto:ceph-users@lists.ceph.com) > http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com > >
_______________________________________________ ceph-users mailing list ceph-users@lists.ceph.com http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
