There is a tool named s3cmd, I use that for minor things. The first time you run it, use `s3cmd --configure`.
Most of my access to the cluster is using the Amazon S3 library. On Thu, Jun 19, 2014 at 1:07 PM, Vickey Singh <vickey.singh22...@gmail.com> wrote: > Hello Craig > > I want to use object storage only NOT cinder and glance. I have > successfully deployed and install RGW , and i can use it from swift client > . > > But i need to access i using any other client like andy s3 client or with > openstack keystone. > > Do you know how can i test it from s3 client , what will be the tool name > or command for that. how you are accessing your object storage. > > Thanks for writing back. > > > > On Thu, Jun 19, 2014 at 8:43 PM, Craig Lewis <cle...@centraldesktop.com> > wrote: > >> Unfortunately, I can't help much. I'm just using the S3 interface for >> object storage. >> >> Looking back at the archives, this question does come up a lot, and >> there aren't a lot of replies. The best thread I see in the archive is >> http://lists.ceph.com/pipermail/ceph-users-ceph.com/2013-November/006283.html >> . >> >> Sébastien Han wrote >> >> >> Well after restarting the services run: >> >> $ cinder create 1 >> >> Then you can check both status in Cinder and Ceph: >> >> For Cinder run: >> $ cinder list >> >> For Ceph run: >> $ rbd -p <cinder-pool> ls >> >> If the image is there, you’re good. >> >> Cheers. >> >> >> There is some follow up in the thread, so you might want to read the >> whole discussion. >> >> >> >> >> On Thu, Jun 19, 2014 at 12:38 AM, Vickey Singh < >> vickey.singh22...@gmail.com> wrote: >> >>> Hello Craig >>> >>> I am following you up on ceph mailing list, looks like you are the >>> expert for CEPH RGW. can you please guide me here. >>> >>> Thanks in advance for your help. >>> >>> - Vickram - >>> >>> >>> ---------- Forwarded message ---------- >>> From: Vickey Singh <vickey.singh22...@gmail.com> >>> Date: Wed, Jun 18, 2014 at 7:57 PM >>> Subject: RADOSGW + OpenStack basic question >>> To: ceph-users@lists.ceph.com >>> >>> >>> Hello Cephers >>> >>> >>> I have been following ceph documentation to install and configure RGW >>> and fortunately everything went fine and RGW is correctly setup. >>> >>> Next i would like to use RGW with OpenStack , and for this i have >>> followed http://ceph.com/docs/master/radosgw/keystone/ , as per the >>> document i have done all the steps. >>> >>> But how should i test RGW and OpenStack integration , the document does >>> not show steps to verify the integration or how to use it further with >>> openstack. >>> >>> Can you please point me to the right direction , for testing Ceph RGW >>> and OpenStack integration . Is there any work / blog on internet by >>> someone which can demonstrate the things “How to use Ceph RGW with >>> Openstack" >>> >>> Please help. >>> >>> >>> Regards >>> Vickram Singh >>> >>> >> >
_______________________________________________ ceph-users mailing list ceph-users@lists.ceph.com http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
