----- Le 2 Oct 24, à 16:21, Victor Rodriguez <vrodrig...@soltecsis.com> a écrit :
>> Hi, >> What makes this cluster a non-local cluster? > It's hosted in OVH's 3AZ, with each host in a different DC, each at around > 30-60km's away from each other, hence the relatively high latency. Yeah. 0.6 to 1ms are expect latencies for that long distances. >> 0'6 and 1 millisecond RTT latency seems too high for all-flash clusters and >> intense 4K write workloads. > I'm fully aware of the limitations imposed by the latency. I was wondering if > there is something that could be done to improve performance under this > conditions. Beyond the limits of physics, no. > Measured performance is more than enough for the workloads that the cluster > will > host, as 4k QD=1 sync writes/reads are not the main I/O pattern. So in the end, the 4K IO benchmark isn't that important. The ability to use this cluster will depend solely on the workload, then. >> The upmap-read or read balancer modes may help with reads but not writes >> where >> 1.2ms+ latency will still be observed. > AFAIK upmap-read isn't available in Reef, at least does not show up in the > docs > [1]. > Thanks! You're right. I forgot you're using Reef. Still you could try setting pg-upmap-primary manually, if I'm not mistaken. Regards, Frédéric. > [1] [ https://docs.ceph.com/en/reef/rados/operations/balancer/ | > https://docs.ceph.com/en/reef/rados/operations/balancer/ ] >> Regards, >> Frédéric. >> ----- Le 1 Oct 24, à 18:23, Victor Rodriguez [ >> mailto:vrodrig...@soltecsis.com | >> vrodrig...@soltecsis.com ] a écrit : >>> Hello, >>> I'm trying to get the most from a Ceph Reef 3 node clusters, with 6 NVMe >>> OSD each. Each node is between 0'6 and 1 millisecond RTT. Obviously >>> performance isn't as good as with local clusters, usually around ~0'2ms. >>> 4k in Q1D1 I/O write request are the most affected by this, as expected, >>> with a performance loss of around 70% from an all local cluster with >>> similar hardware. In general, measurements match the increased latency. >>> Are there any guidelines about what to tune or adjust to get the most of >>> this kind of setups with "high" latencies? >>> Thanks in advance! >>> Victor >>> _______________________________________________ >>> ceph-users mailing list -- [ mailto:ceph-users@ceph.io | ceph-users@ceph.io >>> ] To >>> unsubscribe send an email to [ mailto:ceph-users-le...@ceph.io | >>> ceph-users-le...@ceph.io ] _______________________________________________ ceph-users mailing list -- ceph-users@ceph.io To unsubscribe send an email to ceph-users-le...@ceph.io
