> -----Original Message-----
> From: Tony Mountifield <t...@softins.co.uk>
> Sent: Tuesday, August 06, 2019 5:44 AM
> To: centos@centos.org
> Subject: Re: [CentOS] browsers slowing Centos 7 installation to a crawl
>
> In article <alpine.deb.2.20.1908051718240.19...@mail.cs.ndsu.nodak.edu>,
> Michael Hennebry <henne...@web.cs.ndsu.nodak.edu> wrote:
> >
> > I'll need to do some digging to discover whether my box needs DDR2 or
> DDR3.DDR3
> > I doubt it's DDR4.
>
> Do:
>
> # dmidecode | less
>
> and look for the entries for the existing RAM you have. It will also tell
> you if you have any unpopulated RAM slots ("No module installed").
>
<SNIP>
In the mean time you could enable zswap[1] to make the most out of the ram and
swap you do have.
according to [2] either add 'zswap.enabled=1' to the boot line or 'echo 1 >
/sys/module/zswap/parameters/enabled'
On an EL6 system with 512M of ram (yes that is correct, .5GB, actually ~.4GB
because some is shared with the intel video) I use up-to-date EL6 firefox
reasonably comfortably at home using zswap, setting max_pool_percent to 40.
I am trying to remember which kernel 7 is running (I tend to use the elrepo LT
kernel on EL6) and if it has zswap or only zram.
before switching to the LT kernel I used zram [3] on the machine as swap space
(pretending to be 90% of ram) instead and it works very fast, but when it runs
out (say on a site with lots of JPGs) and you hit real swap again performance
tanks VERY badly. EL7 may have zram setup to swap in such a way that you can
'sysctl start zram' and try it out.
Good luck.
[1] https://en.wikipedia.org/wiki/Zswap
[2] https://www.kernel.org/doc/html/latest/vm/zswap.html
[3] https://en.wikipedia.org/wiki/Zram
--
Even when this disclaimer is not here:
I am not a contracting officer. I do not have authority to make or modify the
terms of any contract.
_______________________________________________
CentOS mailing list
CentOS@centos.org
https://lists.centos.org/mailman/listinfo/centos
