that's what i missed. I misunderstood the directions. Now i know in
the hostname to put :<port> in there. Let me reinstall vmware and try
it again.
Jonathan Berry wrote:
On Jan 26, 2008 10:46 PM, William Warren
<[EMAIL PROTECTED]> wrote:
I am running Centos 5 64 bit. For somer reason i cannot get the windows
client to connect to the server. The port is set to 904 as per the
install but when i try to connect to the server i get the error the
machine is actively refusing it. I do not have a firewall on and the
apache server and everything else is running. I can check the status
webpage in my browser just fine. Any ideas?
Are you specifying to connect to port 904 from the Windows client
(VMware Server Console, I assume)? For example, if your server is at
IP 192.168.0.100, specify 192.168.0.100:904 in the server address box
(likewise, if you connect with a name, just put :904 after the name).
902 is the standard port. However, 902 is allocated in /etc/services
already, so VMware bumps it up to 904. If you want to change this,
edit /etc/services to comment out the two 902 lines, then rerun
vmware-config.pl and tell it to run on port 902. Then you will not
need to specify the port explicitly.
Jonathan
_______________________________________________
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos
--
Registered Microsoft Partner
My "Foundation" verse:
Isa 54:17
_______________________________________________
CentOS mailing list
CentOS@centos.org
http://lists.centos.org/mailman/listinfo/centos
