Wanted to report success, following this procedure:
https://wiki.centos.org/HowTos/Laptops/Wireless/Broadcom
At the bottom, I see something of a compatibility matrix, but a line
representing my specific setup does not exists. So I offer the following
data to show that it works in my environment.
[erik@localhost ~]$ uname -r
3.10.0-327.36.3.el7.x86_64
[erik@localhost ~]$ cat /etc/redhat-release
CentOS Linux release 7.1.1503 (Core)
[erik@localhost ~]$ cat /etc/redhat-release
CentOS Linux release 7.1.1503 (Core)
[erik@localhost ~]$ lspci -nvv
...
0c:00.0 0280: 14e4:4315 (rev 01)
Subsystem: 1028:000c
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR+ FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 64 bytes
Interrupt: pin A routed to IRQ 17
Region 0: Memory at f1ffc000 (64-bit, non-prefetchable) [size=16K]
Capabilities: <access denied>
Kernel driver in use: wl
[erik@localhost ~]$ ls -ld
Downloads/hybrid-v35_64-nodebug-pcoem-6_30_223_271.tar.gz
-rw-rw-r--. 1 erik erik 2928541 Dec 9 21:47
Downloads/hybrid-v35_64-nodebug-pcoem-6_30_223_271.tar.gz
[erik@localhost ~]$
I also wanted to point out, the command provided to extract the TGZ file
downloaded from the Broadcom site is incorrect. Should be:
tar xvzf /path/to/the/tarball/hybrid-v35_64-nodebug-pcoem-6_30_223_271.tar.gz
The "f" flag should be the last flag in the list. Got an error when
entered as provided.
Thanks!
Erik Schminke
_______________________________________________
CentOS-docs mailing list
CentOS-docs@centos.org
https://lists.centos.org/mailman/listinfo/centos-docs
