Initially I had 0.51 both on my linux box and the device. This caused the stdio
problem.
Then, I changed toolchain to 0.50 but dlls on the device were still 0.51 -
problem was still there.
Finally I had 0.50 on both, and the problem went away.
Best regards,
-Pavel
-----Original Message-----
From: [EMAIL PROTECTED] on behalf of Pedro Alves
Sent: Tue 12/18/2007 5:19 PM
To: Pavel Chernikov
Cc: cegcc-devel@lists.sourceforge.net
Subject: Re: [Cegcc-devel] stdio problems with 0.51.0 - fprintf / fputs /
fwrite ..
Pavel Chernikov wrote:
> The same code works just fine in 0.50.
>
> Any suggestions are greatly appreciated.
>
Just to be sure,
did you also update the dll on the device, or just updated
the toolchain on the dev machine ?
--
Pedro Alves
-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
Cegcc-devel mailing list
Cegcc-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/cegcc-devel
-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
Cegcc-devel mailing list
Cegcc-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/cegcc-devel
