Thanks Bill. I downloaded a few of them…none of the smaller ones fully booted 
(only the 16K BASIC got to the “Standby” message) on my test setup but I could 
read and write the disks using the RDOS monitor and it partially passed the “T” 
test (it stopped with a sector error half-way). I’m using a TM100-2A drive 
(DSDD 360K 5.25”). So, I think I feel good that the board works. I would have 
loved to get it to fully boot into something but it’s probably close enough for 
now.

Thanks!

Rich

--
Rich Cini
http://www.classiccmp.org/cini
http://www.classiccmp.org/altair32

On 2/4/17, 7:16 AM, "cctech on behalf of william degnan" 
<cctech-boun...@classiccmp.org on behalf of billdeg...@gmail.com> wrote:

    On Fri, Feb 3, 2017 at 10:54 PM, Richard Cini <rich.c...@verizon.net> wrote:
    
    > All –
    >
    >
    >
    >                 I’m trying to test a Cromemco 16FDC controller…long story
    > but it’s part of a QDOS project. I’m looking for recommendations on a 
5.25”
    > disk image I could use for testing. The system is simple – 16FDC, CompuPro
    > RAM17 (with $C0 block disabled), and a Z80 card. The 16FDC RDOS ROM works,
    > so I can issue commands but I need to test the disk interface part.
    >
    >
    >
    >                 Any recommendations would be appreciated. Thanks!
    >
    >
    >
    >
    >
    http://vintagecomputer.net/disk_images/Cromemco/
    
    One of these should work, note txt files that explain some of them.
    
    Bill
    


Reply via email to