Hi, Apologies for the off-topic question, but does anyone have any experience in using the Cubify 3D printer (http://www.cubify.com/) for printing protein models? Are the models robust? Is the resolution sufficient? The unit price suggests that the printer is very low-end (though the consumables are not that cheap).
sincerely Mike Lawrence Associate Professor and WEHI Fellow Division of Structural Biology Walter and Eliza Hall Institute of Medical Research 1G Royal Parade, Parkville Victoria 3052, AUSTRALIA Tel. 61-3-9345-2693 Fax 61-3-9345-2686 Email: lawre...@wehi.edu.au ______________________________________________________________________ The information in this email is confidential and intended solely for the addressee. You must not disclose, forward, print or use it without the permission of the sender. ______________________________________________________________________
