Thank you! this works perfectly fine! (I was not smart enough to put the path into both boxes)
Yes, had to change forward to backward slash (or how one calls them) and it is saved now. Thank you very much!!! Cheers, Tanya On Fri, Jun 17, 2011 at 4:30 PM, Zhijie Li <zhijie...@utoronto.ca> wrote: > ** > Hi Tatyana, > > It is funny that I just had that same problem a few days ago. > > Here is the solution: > > First of all, install Ghostgum and Ghostscript to your computer- which you > have done. I installed them to my C:\Program Files\ directory. > > Then in CCP4i->system configuration->Config CCP4interface->Hardware > resources, remove those default "xv"(the linux equivalent as I remember) > lines, then make a new line, fill the path to the gsview32.exe into both > brackets: > > Enter names and commands for Postscript Viewers > C:/Program Files/Ghostgum/gsview/gsview32.exe > C:/Program Files/Ghostgum/gsview/gsview32.exe > > Please also refer to the attached screenshot. > > When everything is set correctly, the behavior of the program is that when > you ask the ccp4i to display a .plt file, it fires up the gsview, and the > map slices are displayed in a multipage ps file. > > Zhijie > > > > *From:* Tatyana Sysoeva <tatyanasyso...@gmail.com> > *Sent:* Friday, June 17, 2011 12:53 PM > *To:* CCP4BB@JISCMAIL.AC.UK > *Subject:* [ccp4bb] Ghostview in CCP4 configure interface > > Hi! > > > I am having a problem of visualizing the PLT files in CCP4 6.1.13 CCP1 > interface 2.0.7 running on Windows 7/64. > I installed the GSscript and GSview but I am not sure how to change > parameters in the System administration. > > Any help and advice will be highly appreciated! > > > >
