I attended yesterday the CCIE SP Lab, the lab was huge and time management is for sure a big part of the Lab but compare to the R&S this one is much easier no tricks I enjoyed the lab.
Anyhow just before the lunch I had a sheet to track the progress and I calculated that I scored around the 60 points, after the break I started again and I continued where I left well this time I was doing some configuration after I did that config on 4 routers I figured out that I used wrong ASN/Process ID so I decided to corrected mistake using the no command and what happens that router crashed and it was an IOS router so when that router crashed the whole rack crashed with it, only IOS-XR was working because that was not virtual after the proctor corrected that issue after 10 min he gave me extra 15 min but I lost where I left and totally lost my focus. This is not the only issue I had with the virtual routers, I did some configuration but it didn't work and I was 200% sure that my config is correct I also verified CISCO DOC but just that config on IOU didn't work! I don't understand why cisco use virtual for this LAB, I'm sure when you utilize the router with many config what is normally what you do at this SP Lab like configurations of different technologies IOU start either to crash or do some unpredicted behavior its ready for CCNP lab or CCIE R&S troubleshooting but relay not for the SP 8 hour lab full config. Long story short I still didn't get the score report but according to my own score sheet at the end of the lab I had 74 point I hop I'm wrong.
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and Looking for a job? Check out www.PlatinumPlacement.com
