Matt, I never noticed this. Afaik, this is not a dynamips issue but an encapsulation issue as the message states. It may need to be changed.
On Mon, Mar 22, 2010 at 12:25 AM, Matt Hill <[email protected]> wrote: > The question asks to use ARP for L2/L3 mapping. Also it stipulates to > use aal5mux encapsulation... > > So... > > interface ATM1/0.100 point-to-point > ip address 11.0.0.1 255.255.255.252 > no atm enable-ilmi-trap > ! > ip classless > ! > no ip http server > ! > > R1(config-if-atm-vc)#protocol ip inarp ? > broadcast Pseudo-broadcast > no Prevent Pseudo-broadcast on this connection > <cr> > > R1(config-if-atm-vc)#protocol ip inarp > Cannot run InARP on this connection. InARP is only supported on > aal5snap encapsulation. > R1(config-if-atm-vc)# > > This does happen to be dynamips. Is this an IOS limitation on the 7200? > > Cheers, > Matt > > CCIE #22386 > CCSI #31207 > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > -- Bryan Bartik CCIE #23707 (R&S, SP), CCNP Sr. Support Engineer - IPexpert, Inc. URL: http://www.IPexpert.com
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
