No, there are no MPLS-enabled versions for XM Routers. At least not a 12.4 IOS version.
You'll find some 12.3 IOS versions that implement MPLS. But of course that would be a bit old. The command syntax may be different. So I think that you should replace it with a 2811. 2811's are very cheap these days, compared to what they used to cost. In fact, they nos cost almost the same as XM Routers. Hope this helps. ________________________________ From: Joe S <[email protected]> To: "[email protected]" <[email protected]> Sent: Friday, September 13, 2013 8:10 AM Subject: [OSL | CCIE_RS] MPLS on a 2621XM Hi all - I was happily cruising along with my new (to me) rack and hit a brick wall with MPLS. My R6 for the IPX topology is a 2621XM. And no matter what I can't seem to find a version of IOS that will allow me to run MPLS. I'm currently running c2600-spervicesk9-mz.124-25c.bin. I'd previously had loaded c2600-advipservicesk9-mz.124-25d.bin. When I go to the config there just plain aren't any commands that start with "mpls". Can anyone tell me if there's a better version I should be running, or am I going to be having to order another model router to replace this thing? I'm hoping not because that means I'll have to order serial cards as well and that's just a pain I'd like to avoid. _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
