What version of code are you running on what hw? -max
Sent from my iPad On May 5, 2012, at 12:40 AM, Fulvio allegretti <[email protected]> wrote: > > HI guys, > > I bumped into this before, and againg tonight, just spent a good 30 minutes > on it. > > Framre-realy set full meshed. Using ipxpert topology. Set up OSPF - > restrictions do change ospf network type or in other words used neighbor > command, R2 is the DR - R4 Bdr, look at this on R5: > R5(config)#do show run | sec ospf > router ospf 1 > log-adjacency-changes > area 0 authentication message-digest > network 192.168.10.5 0.0.0.0 area 0 > network 192.168.25.5 0.0.0.0 area 0 > network 200.0.0.5 0.0.0.0 area 0 > neighbor 192.168.10.2 priority 150 > neighbor 192.168.10.4 priority 100 > > R5(config)#int se 0/0/0 > R5(config-if)#ip ospf prio 0 > > R5(config-if)#do show run | sec ospf > router ospf 1 > log-adjacency-changes > area 0 authentication message-digest > network 192.168.10.5 0.0.0.0 area 0 > network 192.168.25.5 0.0.0.0 area 0 > network 200.0.0.5 0.0.0.0 area 0 > > R5(config-if)#ip ospf prio 1 > R5(config-if)#do show run | sec ospf > router ospf 1 > log-adjacency-changes > area 0 authentication message-digest > network 192.168.10.5 0.0.0.0 area 0 > network 192.168.25.5 0.0.0.0 area 0 > network 200.0.0.5 0.0.0.0 area 0 > neighbor 192.168.10.2 priority 150 > neighbor 192.168.10.4 priority 100 > R5(config-if)# > > It's magic, set the priority of the interface to 0 and the neighbor commands > vanishes from the config. Has anybody else seen this before? > The thing is that the neighbor command seems to be active even when it > doesn't show. If you type neigh 192.168.10.6 (that would be R6, the other > router in this fully meshed set up which also has priority 0) you'll see the > log messages on the console of R6. do show run on R5 no neighbor command to > be seen (did not use any substance tonight, i swear). This could be at least > annoying, not sure if it dangerous yet. > On a back to back frame-realy set up I don't get the same behaviour. > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
