Thanks. I got it working by redistributing connected tied to a route map that matched the ip of the serial interface. I'm confused as to why only the connected serial interface would not show up in ripng when I redistributed eigrp.
V/r, Ryan Sent from my iPad On May 3, 2012, at 6:53 PM, Oluwagbenga Oyebande <[email protected]> wrote: > Have you tried adding redistribute connected under the process. I'm not sure > the IPv6 include-connected keyword always delivers expected results. > > On 3 May 2012 10:31, Ryan Krcelic <[email protected]> wrote: > In Lab 32 I have RIPnG and EIGRP setup between R7 and R8 and I am > redistributing between the two. I have the include-connected statement on > my redistribution, but the s0/0/0 interface does not get redistributed into > rip. Everything else is good including the loopback but I cannot ping > s0/0/0 on R7 or R8. > > Respectfully, > > Ryan Krcelic > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs > > > > -- > Olugbenga Oyebande > MD, DAIT > 234-803-302-5287 > http://www.dait-ng.com > Cisco Networks, Network Security & Quality of Service > DAIT Linux Enterprise Network Servers, Web Portal Projects > Broadband Internet Deployment & ISP Consultancy > View Olugbenga Oyebande's profile > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
