Hi People,
I have just put together a home lab, all is OK except an issue I am having with the access server The terminal server cannot connect the 2500 routers (backbones) I can login to these routers using normal console cable with nothing special The terminal server can connect to all other servers with no issues! The message I am getting is BB1 open and then nothing and no output at all I have tried to swap cables with no luck sh vers below Cisco Internetwork Operating System Software IOS (tm) 3000 Software (IGS-I-L), Version 11.1(8), RELEASE SOFTWARE (fc1) Copyright (c) 1986-1996 by cisco Systems, Inc. Compiled Thu 05-Dec-96 12:16 by tamb Image text-base: 0x0301FF88, data-base: 0x00001000 ROM: System Bootstrap, Version 5.2(8a), RELEASE SOFTWARE ROM: 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(8a), RELEASE SOFTWARE (fc1) Access-Server uptime is 1 hour, 43 minutes System restarted by power-on System image file is "flash:igs-i-l.111-8", booted via flash cisco 2511 (68030) processor (revision D) with 2048K/2048K bytes of memory. Processor board ID 02280119, with hardware revision 00000000 Bridging software. X.25 software, Version 2.0, NET2, BFE and GOSIP compliant. 1 Ethernet/IEEE 802.3 interface. 2 Serial network interfaces. 16 terminal lines. 32K bytes of non-volatile configuration memory. 8192K bytes of processor board System flash (Read ONLY) Configuration register is 0x2102 Any ideas? Cheers Mena _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
