Cedric as a rule of thumb the diagram is always correct. In the real lab however you would want to bring this to the proctors attention for clarification.
________________________________________ From: [email protected] [[email protected]] On Behalf Of Cedric King [[email protected]] Sent: Saturday, October 08, 2011 2:43 PM To: [email protected] Subject: [OSL | CCIE_RS] Lab4 vl 2 issue Hi All, I'm going through vl 2 and noticed a mistake... and wanted to get some clarity... Task 1.1 when assigning interface to the correct vlan, R1 to cat1 is assigned to vlan 20.. but the startup configs has this port set up as a routed port.. and vise versa for port to cat 2.. I'm also looking at the diagram and noticed this issue as well.. Can someone verify how this is suppose to be... is the diagram correct or the startup configs ? Cedric _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com UHS Confidentiality Notice: This e-mail message, including any attachments, is for the sole use of the intended recipient (s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution of this information is prohibited. If this was sent to you in error, please notify the sender by reply e-mail and destroy all copies of the original message. _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
