Hey Experts!
I understand the general rule when configuring IPv6 addresses on our router
interfaces is to hardcode the link-local address like this {R1 = fe80::1 ; R2 =
fe80::2} That makes sense on physical interfaces, however should we get into
the habit of doing the same this for our loopbacks as well? Does it matter?
Thanks in advance!
Steve
UHS Confidentiality Notice: This e-mail message, including any attachments, is
for the sole use of the intended recipient (s) and may contain confidential and
privileged information. Any unauthorized review, use, disclosure or
distribution of this information is prohibited. If this was sent to you in
error, please notify the sender by reply e-mail and destroy all copies of the
original message.
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
