That is a good suggestion but I don't see it. Here are the requirements:
Ensure that the lab switches are configured according to the layer 2 tables and diagrams (I don't see anything to indicate trunking encapsulation on any of the drawings or tables) All EtherChannel interfaces must be attempting to establish EtherChannel links using LACP. All inter-switch links should automatically negotiate trunking. Lower switch should wait higher-numbered switch before it starts trunking. Vlan-1112 should be allowed only links between Cat1 and Cat2. Vlan-1314 should be allowed only on links between Cat3 and Cat4. -Marc On Sun, Apr 3, 2011 at 11:48 AM, Don Lundquist <[email protected]> wrote: > To take a stab at this without review of the specific requirements stated, my > first question would be is there reference to how the tasks are worded... > Does it state "use industry standards"...? LACP is an industry standard and > so is D1Q..? > > Don > > > On Apr 3, 2011, at 12:21, "marc abel" <[email protected]> wrote: > >> Vol 3 lab 2 requires dynamic trunking between the switches, and makes >> certain requirements about LACP on the port channels. I get all of >> this but am curious about 1 thing. >> >> The solutions guide shows specifying Dot1q as the encapsulation type. >> I don't see a requirement for this. Is there some later task that >> makes this necessary? I haven't been able to spot it yet if so. >> >> Or is it just extra config? Personal preference? >> >> Thank you, >> >> Marc >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
