No, it didn't make a difference. It works with the default 0/0 area 0 OSPF config.
Thanks for chiming in, Steve. Regards, Jay McMickle- CCNP, CCSP, CCDP, MCSE http://mycciepursuit.wordpress.com/ ________________________________ From: "Di Bias, Steve" <[email protected]> To: Jay McMickle <[email protected]>; IPExpert Online <[email protected]> Sent: Thu, December 30, 2010 2:31:03 PM Subject: RE: [OSL | CCIE_RS] Lab 17.5 I asked myself the same question when I was doing this lab but was moving pretty fast and never bothered to ask. Does it make a difference if you leave it? It shouldn't break the NAT, but I haven't tested. Looking forward to a response on this one as well. Thank you, Steve Di Bias Network Engineer - Information Systems Valley Health System - Las Vegas Office - 702- 369-7594 Cell - 702-241-1801 [email protected] -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Jay McMickle Sent: Thursday, December 30, 2010 10:52 AM To: IPExpert Online Subject: [OSL | CCIE_RS] Lab 17.5 Lab 17.5- I understand the NAT portion here on R4. What I don't understand, and I've seen this previously, is why we need to change the OSPF configuration. Currently, it's configured for all interfaces. The section requirements only mention not natting the f0/1. The recommended configuration is to remove the 0/0 for OSPF configuration, and only add back the Serial, Loopback, and F0/1 (excluding the NVI and F0/0. Why is that? router ospf 1 log-adjacency-changes network 0.0.0.0 255.255.255.255 area 0 Regards, Jay McMickle- CCNP, CCSP, CCDP, MCSE http://mycciepursuit.wordpress.com/ _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com UHS Confidentiality Notice: This e-mail message, including any attachments, is for the sole use of the intended recipient (s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution of this information is prohibited. If this was sent to you in error, please notify the sender by reply e-mail and destroy all copies of the original message. _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
