I have not looked at the DSG or the WB but I would ask if you are redistributing between IGP and BGP for the appropriate VRFs
From: Amer Mustafa [mailto:[email protected]] Sent: December-10-10 7:11 PM To: [email protected] Cc: Jason Maynard Subject: WORKBOOK 1 - LAB29 ===> TASK 9. WB1 ==> LAB29 ==> TASK 9. After completing the configuration for this task, shouldn't i receive the details of the VRF VPNB on R6 ? since the R9 is the route-reflector for address-family vpnv4 ? on R6 : when i do : show ip bgp vpnv4 all , it shows nothing : R6#show ip bgp vpnv4 all R6# on R9 : R9(config)#do show ip bgp vpnv4 all BGP table version is 3, local router ID is 200.0.0.9 Status codes: s suppressed, d damped, h history, * valid, > best, i - internal, r RIB-failure, S Stale Origin codes: i - IGP, e - EGP, ? - incomplete Network Next Hop Metric LocPrf Weight Path Route Distinguisher: 689:100 *>i150.50.78.0/30 200.0.0.8 0 100 0 ? *>i200.0.0.7/32 200.0.0.8 2297856 100 0 ? ===================================== bgp section config on R9 is : R9(config)# R9(config)#do show run | s bgp router bgp 689 no bgp default ipv4-unicast bgp log-neighbor-changes neighbor P peer-group neighbor P remote-as 689 neighbor P update-source Loopback0 neighbor 200.0.0.6 peer-group P neighbor 200.0.0.8 peer-group P ! address-family ipv4 neighbor P route-reflector-client neighbor 200.0.0.6 activate neighbor 200.0.0.8 activate no auto-summary no synchronization network 200.0.0.9 mask 255.255.255.255 exit-address-family ! address-family vpnv4 neighbor P send-community extended neighbor P route-reflector-client neighbor 200.0.0.6 activate neighbor 200.0.0.8 activate exit-address-family R9(config)# Any clue ?
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
