I would also add the capabilities will differ on each type / revision of the lines cards.
You better issue a sho port capa QOS scheduling: rx-(1p1q4t), tx-(1p2q2t) QOS queueing mode: rx-(cos), tx-(cos) That page will help you : http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008015bf98.shtml This is a good place to start before planning your QOS deployment. On Mon, Aug 2, 2010 at 7:53 AM, Marko Milivojevic <[email protected]> wrote: > The only consistent thing about QoS on Catalyst switches is that it's > horribly inconsistent. > Cat6500 is not a single platform in terms of QoS. Different modules offer > different features. Different Supervisors, too. Syntax-wise, some things are > similar to 3550 and 3560, while others are different. When using "WAN" line > cards, QoS configuration on those interfaces is more similar to routers than > other Cats. > > > -- > Marko Milivojevic - CCIE #18427 > Senior Technical Instructor - IPexpert > Mailto: [email protected] > Telephone: +1.810.326.1444 > Fax: +1.810.454.0130 > Community: http://www.ipexpert.com/communities > :: Sent from my phone. Apologies for errors and brevity. :: > On Aug 2, 2010, at 3:19, Najeeb <[email protected]> wrote: > > > Dears, > > i am new on this. Tyson how r u ? hope you will answer me on this ! > > "Is it possible that L3 switches like 6500 will use the same commands or > features of 3650 or 3550 , in terms of QoS ingress and egress policies or > commands " ???? > > > waiting for reply.. > Thanks,. > Najeeb ( following for a CCIE .). > > > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
