The lab requirements were to enable authentication for RIP updates as follows
R2 and R4
R2 and R5
R2 and R6
R5, R6, and R7
Since R2 has two connections to R5 I created one key chain and applied it to
both the s0/1/0.25 and s0/2/0 interfaces, however the DSG only shows the
configuration on s0/1/0.25, and not on the s0/2/0
I know that Cisco best practice is one key-chain, per interface, per protocol,
however was I wrong in my thinking here, the question stated between R2 and R5
and to me that meant both links.
Thanks!
Steve Di Bias
UHS Confidentiality Notice: This e-mail message, including any attachments, is
for the sole use of the intended recipient (s) and may contain confidential and
privileged information. Any unauthorized review, use, disclosure or
distribution of this information is prohibited. If this was sent to you in
error, please notify the sender by reply e-mail and destroy all copies of the
original message.
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
